Beginners
From Schematic to Pin Map: Driving PdfCraft, PhotoCraft and VectorCraft from Claude Code over MCP
Three open-source ArtCraft desktop apps expose MCP servers, which lets Claude Code read a schematic PDF, draw a vector pin map from a Zephyr overlay, annotate a board photo and assemble a lab handout. This is a step-by-step guide to the setup and a record of documenting the nRF52840.
MECE module planner (Jan 2027 Entry)
A holding post with an interactive module selection tool for MECE students entering DCU Engineering in January 2027. Please contact Richard Bolger directly if
MCTY module planner (Jan 2027 entry)
If you start MCTY in January 2027, the programme runs over 20 months. In January you register for your three Semester 2 modules only. You register for the rest of the programme in September 2027: three Semester 1 modules, two Semester 2 modules, EEN1101 and EEN1095.
MECE Module Selection (Sep 2026 Entry)
An interactive selection tool for students beginning MECE in September 2026
MCTY Module Selection (Sep 2026 Entry)
An interactive selection tool for students beginning MCTY in September 2026
The Zephyr Devicetree: An Interactive Demo
A gentle, but complete introduction to the Zephyr devicetree, taught through the one thing every beginner gets wrong - which way round an LED is wired. Built from nothing on a low-cost Seeed XIAO nRF52840, with three onboard LEDs, one external LED wired deliberately backwards, and a button.